Wednesday, March 23, 2011

CNC Robot Conversion

In early 2011, I acquired a Janome/Fisnar epoxy dispensing robot with a damaged linear guide for $8. The original cost was in the tens of thousands, so I consider this a great bargain. And it is...if I had the software to drive it. It's an old model without (inexpensive) support, so I have decided to strip the robot of its drives, circuit boards and stepper motors. The robot's frame consists of a large arm of aluminum casting that is fixed to a base of similar material. The arm is stationary and carries the X/Z axis along its cantilevered extension via a belt-drive over the Y axis. The Y-axis consists of a belt driven table that floats slightly above the base. The table is attached to a linear guide under the base.

I had been collecting various bits and bobs for a CNC controlled "something" for about six years. Among those was a mint set of 400W Mitsubishi servo motors and drives from a Miyakoshi transport that was scrapped out at work. The motors worked to move print heads in and out of the press for cleaning/repair and had to maintain a ridiculously tight repeatability over its 42" travel.  I think I paid $35(!) for four motors, ball screws, THK linear guides and a bunch of steel frames. I later purchased three matching servo drives (MR-J2S-40B) that turned out to operate over a PLC-controlled digital bus that can be very expensive - and I would need to learn a new system. I decided to buy a different version (MR-J2S-40A) of the same drives that can accept step/direction inputs which forced me to delay the project for another year while I secured the new drives. They are generally in high demand and fetch $300-500 each. But, thanks to eBay and patience, I was able to secure them for $75-110 each.

The next steps are to verify that the new motors fit, build adapters where necessary and strip the current equipment from the robot.

No comments:

Post a Comment