Welcome to my repository of thoughts related to the projects and hobbies in which I participate. There's very little instructional information in this blog; it's more like a place to tell stories about my projects and hobbies. So, if you've happened across the blog, please remember that I'll likely teach you nothing.
Unless you just like to watch. In that case...have at it.
/human:technology/
Wednesday, March 23, 2011
CNC Robot Conversion
In early 2011, I acquired a Janome/Fisnar epoxy dispensing robot with a damaged linear guide for $8. The original cost was in the tens of thousands, so I consider this a great bargain. And it is...if I had the software to drive it. It's an old model without (inexpensive) support, so I have decided to strip the robot of its drives, circuit boards and stepper motors. The robot's frame consists of a large arm of aluminum casting that is fixed to a base of similar material. The arm is stationary and carries the X/Z axis along its cantilevered extension via a belt-drive over the Y axis. The Y-axis consists of a belt driven table that floats slightly above the base. The table is attached to a linear guide under the base.
I had been collecting various bits and bobs for a CNC controlled "something" for about six years. Among those was a mint set of 400W Mitsubishi servo motors and drives from a Miyakoshi transport that was scrapped out at work. The motors worked to move print heads in and out of the press for cleaning/repair and had to maintain a ridiculously tight repeatability over its 42" travel. I think I paid $35(!) for four motors, ball screws, THK linear guides and a bunch of steel frames. I later purchased three matching servo drives (MR-J2S-40B) that turned out to operate over a PLC-controlled digital bus that can be very expensive - and I would need to learn a new system. I decided to buy a different version (MR-J2S-40A) of the same drives that can accept step/direction inputs which forced me to delay the project for another year while I secured the new drives. They are generally in high demand and fetch $300-500 each. But, thanks to eBay and patience, I was able to secure them for $75-110 each.
The next steps are to verify that the new motors fit, build adapters where necessary and strip the current equipment from the robot.
I had been collecting various bits and bobs for a CNC controlled "something" for about six years. Among those was a mint set of 400W Mitsubishi servo motors and drives from a Miyakoshi transport that was scrapped out at work. The motors worked to move print heads in and out of the press for cleaning/repair and had to maintain a ridiculously tight repeatability over its 42" travel. I think I paid $35(!) for four motors, ball screws, THK linear guides and a bunch of steel frames. I later purchased three matching servo drives (MR-J2S-40B) that turned out to operate over a PLC-controlled digital bus that can be very expensive - and I would need to learn a new system. I decided to buy a different version (MR-J2S-40A) of the same drives that can accept step/direction inputs which forced me to delay the project for another year while I secured the new drives. They are generally in high demand and fetch $300-500 each. But, thanks to eBay and patience, I was able to secure them for $75-110 each.
The next steps are to verify that the new motors fit, build adapters where necessary and strip the current equipment from the robot.
Subscribe to:
Posts (Atom)